MOTU UltraLite-mk3 Hybrid Betriebsanweisung PDF herunterladen (Seite 21)

INSTALLING THE ULTRALITE-MK3 HYBRID HARDWARE

adjust these trims using CueMix FX, see “Input

trim” on page 73. To adjust the trims using the

front panel LCD:

1 Push the PARAM knob repeatedly until you see

CUEMIX in the LCD display.

2 Push the CHANNEL knob repeatedly until you

see “I:” (which stands for Input) in the CHANNEL

section of the LCD (Figure 3-3).

3 Turn the CHANNEL KNOB until you see the

desired analog input or input pair. For example,

analog inputs 1-2 appear as “I:An 1-2”

(Figure 3-3), which means Input analog 1-2.

4 From the factory, analog inputs are grouped in

stereo pairs (1-2, 3-4, etc.) If you need to split a pair

to program it as two individual mono inputs, turn

the PARAM knob until you see PAIR in the

parameter section of the LCD (Figure 3-3). Turn

the VALUE knob to choose MONO. Then turn the

CHANNEL knob again to select the desired input.

Figure 3-3: The settings for analog inputs 1 and 2 (as a pair).

5 After splitting the stereo pair, if necessary, turn

the PARAM knob until you see the TRIM

parameter in the LCD (Figure 3-4):

Figure 3-4: Setting the input trim for a TRS analog input pair.

6 Turn the VALUE knob to adjust the trim.

Separate main outs

The main outputs operate as an independent pair

(they don’t share signal with any other output

pair). In a standard studio conﬁguration, the main

outs are intended for a pair of studio monitors, but

they can also be used as regular outputs for any

purpose. Their reference level is +4dB. Main out

volume is controlled by the VOL knob on the front

panel: push it repeatedly until you see MASTER

and then turn it to adjust the master volume

output. This knob can be programmed to control

any combination of outputs you wish.

S/PDIF

If you make a S/PDIF digital audio connection to

another device, be sure to review the digital audio

clocking issues, as explained in “Connecting and

syncing S/PDIF devices” on page 22.

The UltraLite-mk3 on-board mixer also supplies

12dB of digital trim adjustment for the S/PDIF

input pair, which can be adjusted from CueMix FX

(“Input trim” on page 73) or the front panel (using

the same procedure as explained earlier for

“Quarter-inch analog input trims” on page 20.

CONNECT MIDI GEAR

Connect your MIDI device’s MIDI IN jack to the

UltraLite-mk3’s MIDI OUT jack (Connection A

below). Conversely, connect the MIDI device’s

MIDI OUT jack to the UltraLite-mk3’s MIDI IN

jack (Connection B).

Figure 3-5: Connecting a MIDI device to the UltraLite-mk3.

UltraLite-mk3

rear panel

MIDI Device

MIDI

cables

MIDI

OUT

MIDI

OUT

MIDI

Connection A

Connection B

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 117 118

Kommentare zu diesen Handbüchern

Keine Kommentare

MOTU UltraLite-mk3 Hybrid Betriebsanweisung Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Aufnahmegeräte MOTU UltraLite-mk3 Hybrid